DECT base stations connecting at 10Mbps

Modified on Thu, 18 Sep at 8:08 AM

Low power mode was introduced in 146.87.x.x firmware and reduces connectivity to 10Mbps on DECT base stations. This is enabled by default on new (non-US) bases and can be disabled in the Web UI or provisioned as below:

Source: https://support.yealink.com/en/portal/knowledge/show?id=67c808b7a49c212e3e3dd7b9

Introduction

You can enable the Low Power Mode to reduce power consumption during Base standby.

Set via the Device Interface

On the web user interface, go to Settings > Low Power Mode.

Auto Provisioning

features.low_power_mode

Parameter	Permitted Values	Default	Description
features.low_power_mode	0-Disabled 1-Enabled	0 NOTE Only the European version of the base is enabled by default.	It enables or disables the Low Power Mode to reduce power consumption during BASE standby.